Min. Framing Dims. - Rear Vent Configuration - Travis Industries 21 TRV Installation Manual

Minimum Framing Dimensions - Top Vent Configuration
The fireplace enclosure must
be a minimum 48" above the
base of the fireplace.
NOTE: Do not build into the
area above the fireplace
(except for the required
framing members).
HINT: We recommend
installing the shaded
framing after the fireplace
is in place.
WARNING: A cut-out for the gas line may be
required on the framing.
© Travis Industries
Installation
48" Min.
Firestop
(required)
36"
13-1/2"
20-1/4"
(for qualified installers only)
Vent Clearances:
1" to the sides, 1" below, and 3" above
the vent to combustibles.
4080207
If using an elbow directly off the
fireplace, the vent will be centered
41-3/4" above the base of the
fireplace.
HINT: we recommend reinforcing the
upper corners of the fireplace opening.
6"
1"
Route the electrical line to a position
to the right rear of the fireplace.
Thermostat or Remote
Control Wire (right side)
100-01185_000
1 5
5"