Vision Fitness U70-02 Service Manual page 47

CHAPTER 6: SOFTWARE UPGRADE PROCEDURE
6.1 Software Upgrade Instructions – Continued
4. After the first console is installed, you can remove the RS232 cable from PC to MSP-GANG430 as shown in Figure D.
Connect the other consoles being installed to MSP-GANG430 as shown in Figure E. Press the MSP430 "START" button, the "MODE" LED will to glitter
about 10 sec, if the install passes, the OK green LED will light as shown in Figure F.
Remove the
RS232 cable
.
FIGURE D
3. If the console install
passes, the OK green
LED will light.
2. The "MODE"LED will glitter after
about 10 sec when console be installed
from MSP-GANG430.
5. Install the console onto frame. Then pedal the machine to provide power for the console. Enter into Engineering Mode to confirm if the software has
been installed / upgraded and confirm if the machine type is right.
6. Test the bike for function as outlined in Section 5.20.
1. Press "START"
button.
FIGURE F
FIGURE E
47