Also, during each assembly step, ensure that ALL screws are in place and partially threaded in before completely tightening any ONE screw. STEP STEP STEP STEP A s s e m b l y G u i d e R2600HRT COMMERCIAL FITNESS BIKE STEP STEP...
Page 3
TOOLS & PARTS INCLUDED 5mm Allen Wrench 15mm Pedal Wrench 6mm Allen Wrench Screwdriver 4mm L-Shaped Wrench PARTS BOX Console Mast Cover Water Bottle Heart Rate Chest Strap Color-coded Hardware Bags Pedals/Straps Owner’s Guide Assembly Guide Warranty Card 5mm L-Shaped Wrench...
Page 4
ORANGE BAG M8x65L Screw Quantity: 2 M8 x 20L Screw Quantity: 2 BLUE BAG M8 Lock Washer M8 x 15L Screw Quantity: 7 PINK BAG M8 Lock Washer M8 x 15L Screw Quantity: 2 HARDWARE INCLUDED M8 Lock Washer Quantity: 4 Quantity: 6 Quantity: 2 YELLOW BAG...
STEP Rear Foot STEP STEP STEP Console Mast Console Mast Boot Frame Bracket ORANGE BAG • Install the rear foot with the four lock washers (M8), two inside screws (M8x65L), and two outside screws (M8x20L). Tighten with the 5mm Allen wrench. BLUE BAG •...
PINK BAG STEP • Mount the upper handlebars to the console mast using two lock washers (M8) and two screws (M8x15L). Tighten with the 5mm Allen wrench. • Remove the four mounting screws from the back of the console. Connect the wire harness and heart rate wires that come from the console mast into the plugs located in the back of the console.
GREEN BAG STEP • Attach the seat frame to the sliding seat bracket using four lock washers (M8) and four socket head cap screws (M8x20L) and the 6mm Allen wrench. • Connect Wires A on the seat handlebar to Wires B on the sliding seat bracket.
BLACK BAG STEP • Secure the Lumbar controlled seat back and the seat bottom to the seat frame with eight lock washers (M6) and eight screws (M6x55L). Tighten with the 4mm Allen wrench. • Snap the plastic seat cover into place on the back of the Lumbar controlled seat.