Install securing screws 2 on left
and right with specified torque.
Brake caliper on slider
tube
22 lb/ft (30 Nm)
Remove adhesive tape from
wheel rim.
Braking efficiency is im-
paired if the brake pads are
not correctly bedded against the
disks.
Before driving off, check that the
braking effect kicks in without
any delay.
Operate brakes several times
until brake pads contact brake
disk.
with BMW Motorrad Integral
OE
ABS II
Clip in two retaining clips 1 of
the ABS sensor cable on brake
line.
Inspect to confirm that the
sensor wire is secured at the
clip 3, snap into place as re-
quired.
The cable of the wheel
speed sensor could chafe
through if it comes into contact
with the brake disk.
Make sure that sensor cable is
routed correctly.
Make sure that sensor cable is
routed as shown.
Removing rear wheel
Make sure ground is level and
firm and place motorcycle on
its center stand.
Shift into first gear.
Components of the exhaust
system can be hot.
8
109
z