Stamina Total Body Pro Elliptical 55-1702 Owner's Manual page 8

ASSEMBLY INSTRUCTIONS
STEP 3
NOTE: There is a red strap and a black strap attached inside of the UPRIGHT(6). These straps are to
assist in pulling the SENSOR WIRE(33) and TENSION CABLE(30) through the UPRIGHT(6).
Tie the red strap to the plug end of the SENSOR WIRE(33), and tie the black strap to the cable end of
the TENSION CABLE(30). Pull the red strap from the opening at the top of the UPRIGHT(6) until the
SENSOR WIRE(33) is pulled through and extends out the opening. Pull the black strap until the TENSION
CABLE(30) is pulled through and extends out of the square opening in the side of the UPRIGHT(6) as
shown in the below illustration. Insert the UPRIGHT(6) into the MAIN FRAME(1) and secure with BUTTON
HEAD BOLTS(M8x1.25x20mm)(59), LOCK WASHERS(M8)(75), and ARC WASHERS(M8)(73). Do not
tighten the bolts until STEP 11.
NOTE: Don't remove the straps from the SENSOR WIRE(33) and TENSION CABLE(30) until instructed
to do so in later assembly steps.
Black Strap
Red Strap
8