Stamina Total Body Pro Elliptical 55-1702 Owner's Manual page 11

ASSEMBLY INSTRUCTIONS
WARNING:
The CRANKS(37) require a special tool to remove once assembled. Read all of the
following ASSEMBLY INSTRUCTIONS before attaching the CRANKS(37).
NOTE: 1.
Align the ARROW MARK on the CRANK(37) to the WHITE MARK on the AXLE(12) when
installing the two CRANKS(37) onto the AXLE(12). Refer to inset drawing A.
2. The RIGHT FLANGE NUT(M10x1.25)(40), black color, has right hand threads and is tightened
by turning clockwise. The LEFT FLANGE NUT(M10x1.25)(39), brass color, has left hand threads
and is tightened by turning counterclockwise.
STEP 8
Place the front end of the RIGHT PEDAL ARM(5) on the ROLLER(54) of the FRONT STABILIZER(2).
CRANK(37)
Install the
NUT(M10x1.25)(40). Insert an allen wrench through the hole in the socket wrench to be the handle.
SECURELY TIGHTEN the RIGHT FLANGE NUT(M10x1.25)(40) with the socket wrench. Push the
CAP(41) CRANK(37).
into the
CAUTION:
It is possible to assemble the
C.
and The
direction from the right side. Refer to the below illustration. Use the same procedure as above
to assemble the
White Mark
Arrow Mark
AXLE(12)
onto the with TOOTH LOCK WASHER(M8)(38) and RIGHT FLANGE
CRANKS(37)
CRANK(37)
on the
LEFT PEDAL ARM(4).
A.
the wrong way as shown in inset drawings
LEFT PEDAL ARM(4)
11
must be assembled in the opposite
Allen Wrench
Socket Wrench
CRANK
B
B.
C.