Number Of Rings - AT&T TL92271 User Manual

Answering system
Answering system settings

Number of rings

When the answering system is turned on, it answers all incoming home calls
after the number of rings set. You can choose from 2, 3, 4, 5, or 6 rings; or
toll saver. With toll saver selected, the answering system answers after 2
rings when you have new messages, and after four rings when you have no
new messages.
This enables you to check for new messages and avoid paying unnecessary
long distance charges if you are calling from out of your local area. The
default number of rings is four.
To set the number of rings:
1. Press MENU
main menu.
2. Press CID or DIR to highlight Answering sys, then
press SELECT.
3. Press CID or DIR to highlight Ans sys setup, then
press SELECT.
CID or DIR to highlight # of rings, then
4. Press
press SELECT.
CID or DIR to choose from 6, 5, 4, 3, 2 or
5. Press
Toll saver, then press
NOTE: If you set the number of rings for the answering system as 2 or 3 rings, the
caller ID announce feature may not have enough time to announce the caller's
full information.
on the handset in idle mode to enter the
SET to save. You hear a confirmation tone.
78
ANS SYS SETUP
Cal l screening
# of rings
Remote code
BACK SELECT
# OF RINGS
6
5
4
BACK SET