Application Work Groups - Honeywell Xenon 1900 User Manual

To rename scanners with sequential, numeric names, scan the bar codes below. Scan the Reset code after each name change
and wait for the scanner to relink to the base or Access Point before scanning a bar code to rename the next scanner.
0001
0003
0005
0007
You may also scan the Scanner Name bar code below and scan a number for the scanner name. For example, if you wanted to
name the linked scanner "312," you would scan the bar code below, scan the 3, 1, and 2 bar codes on the
inside the back cover of this manual, then scan Save. Scan the Reset bar code and wait for the scanner to relink to the base.

Application Work Groups

Your cordless system can have up to 7 scanners linked to one base or Access Point. You can also have up to 7 work groups. If
you want to have all of the scanners' settings programmed alike, you don't need to use more than 1 work group. If you want
each scanner to have unique settings (e.g., beeper volume, prefix/suffix, data formatter), then you may program each scanner to
its own unique work group and may program each scanner independently. For example, you might want to have multiple work
groups in a retail/warehouse application where you need to have different data appended to bar codes used in the warehouse
area versus the retail area. You could assign all the scanners in the retail area to one work group and those in the warehouse to
Scanner Name
0002
0004
0006
Reset
Programming Chart
3 - 19