Paging Pitch; Error Indicators; Beeper Pitch - Base Error; Number Of Beeps - Base Error - Honeywell Xenon 1900 User Manual

Pitch
Paging
When you press the Page button on the base or Access Point, the scanners associated with that base or Access Point will
begin beeping (see Page Button
of the following bar codes. Default = Low.
* Low (1000 Hz)
High (4200 Hz)

Error Indicators

Beeper Pitch - Base Error

Note: This feature only applies to the CCB01-010BT base.
The CCB01-010BT base can be configured to beep at a particular pitch when an error occurs, such as transmission prob-
lems to a host system. The beeper pitch codes modify the pitch (frequency) of the error tone the base emits when there is
an error. Default = Low.
* Razz (250 Hz)
High (4200 Hz)

Number of Beeps - Base Error

Note: This feature only applies to the CCB01-010BT base.
3 - 8
on page 3-4). You can set the pitch of the paging beep for each scanner by scanning one
Medium (3250 Hz)
Medium (3250 Hz)