Page Button; About The Battery; Charging Information; Battery Recommendations - Honeywell Xenon 1900 User Manual

Page Button

When you press the Page button on the base or Access Point, the scanners associated with that base or Access Point will begin
beeping (3 short and 1 long beep). If you pull the trigger on a scanner that is beeping in response, or press the Page button on
the base or Access Point a second time, all associated scanners will stop beeping. See
tion about Page Button settings.
Note: If you are using a Xenon 1902HC model, refer to
Button settings.

About the Battery

There is a danger of explosion if the batteries are incorrectly replaced. Replace the batteries with only the same or
!
equivalent type recommended by the manufacturer. Dispose of used batteries according to the recycle program for
batteries as directed by the governing agency for the country where the batteries are to be discarded.
Power is supplied to the cordless scanner by a rechargeable battery that is integrated in the scanner handle. Batteries are
shipped approximately 30% to 60% charged. The battery should be charged for a minimum of 4 hours before initial use to
ensure optimal performance.

Charging Information

The battery is designed to charge while the scanner is positioned in the cordless base unit. Refer to
LED Sequences and Meaning, page 3-5, for an interpretation of the Charge Status indicators. Refer to
(page 3-9) if you need to charge a scanner without linking it to the base.
Place the scanner in the base that is connected to an appropriate power supply. Use only a Listed Limited Power Source
(LPS) or Class 2 type power supply with output rated 5 to 5.2Vdc, 1A.
Note: If you are powering the base through the interface cable (for example, a USB cable) and not using an external power
supply plugged into the aux port, the current available for charging is reduced and charge times are increased.

Battery Recommendations

• The battery is a lithium ion cell and can be used without a full charge, and can also be charged without fully discharging,
without impacting the battery life. There is no need to perform any charge/discharge conditioning on this type of battery.
• Keep the base connected to power when the host is not in use.
• Replace a defective battery immediately since it could damage the scanner.
• Although your battery can be recharged many times, it will eventually be depleted. Replace it after the battery is unable
to hold an adequate charge.
• If you are not sure if the battery or charger is working properly, send it to Honeywell International Inc. or an authorized
service center for inspection. Refer to
Caution:
Use only Honeywell Li-ion battery packs, model number BAT-SCN01, rated 3.7 Vdc, 7.4Whr in this device. Use
of any non-Honeywell battery may result in damage not covered by the warranty.
Safety Precautions for Lithium Batteries
• Do not place batteries in fire or heat the batteries.
• Do not store batteries near fire or other high temperature locations.
• Do not store or carry batteries together with metal objects.
• Do not expose batteries to water or allow the batteries to get wet.
• Do not connect (short) the positive and negative terminals, of the batteries, to each other with any metal object.
• Do not pierce, strike or step on batteries or subject batteries to strong impacts or shocks.
• Do not disassemble or modify batteries.
Caution:
Danger of explosion if batteries are incorrectly replaced. Dispose of used batteries according to the recycle
program for batteries as directed by the governing agency for the country where the batteries are to be
discarded.
3 - 4
Page Button and Presentation Modes
Customer Support on page 15-1 for additional information.
Paging on page 3-7 for further informa-
on page 5-2 for additional Page
Base/Access Point
Charge Only Mode