Connecting With Keyboard Wedge - Honeywell Xenon 1900 User Manual

CCB02-100BT/CCB05-
100BT Base USB
Connection:
Note: The power supply must be ordered separately, if needed.
3. If you are connecting a CCB01-010BT Base, make sure the cables are secured in the wireways in the bottom of the
cordless base and the base sits flat on a horizontal surface. If you are connecting a CCB02-100BT or CCB05-100BT
Base, see Mounting a CCB02-100BT/CCB05-100BT Base
4. The scanner beeps.
5. Verify the scanner or cordless base operation by scanning a bar code from the
manual.
The unit defaults to a USB PC Keyboard. Refer to
For additional USB programming and technical information, refer to "USB Application Note," available at
wellaidc.com.

Connecting with Keyboard Wedge

A scanner or cordless base can be connected between the keyboard and PC as a "keyboard wedge," where the scanner
provides data output that is similar to keyboard entries.
Note: The Granit 1980i does not support the keyboard wedge interface.
The following is an example of a keyboard wedge connection:
1. Turn off power and disconnect the keyboard cable from the back of the terminal/computer.
on page 1-9.
page 2-3 for other USB terminal settings.
Sample Symbols in the back of this
www.honey-
1 - 3