Table of Contents
Advertisement
If the area to be mowed includes secondary areas based on the defi nition given in the chapter "Preparation and Marking the Boundaries of the
Work Areas", then it is necessary to program the secondary areas so the robot knows how to reach them and how many times.
EN
SECONDARY AREA : Function for defi ning the automatic mowing of a secondary area.
-
Percentage: allows setting the dimensions of the secondary area to
be mowed in respect to entire lawn surface. Below is a table to use as
a guide for confi guring a secondary area:
•
20% indicates a very small area.
•
30% Indicates an area which is approximately one third of the entire
garden.
•
50% Indicates an area which is approximately half of the entire
garden.
•
80% Indicates a secondary area which is bigger than the primary
area.
•
100%. The robot will follow the perimeter wire to mow the secondary
area each time it exits the charging station.
-
Distance: This allows setting the distance necessary for the robot to reach the internal part of the secondary area following the perimeter
wire. It is recommended to measure half the distance of the secondary area to ensure that the robot starts working inside that area.
-
Direction: Indicates the shortest direction for reaching the secondary area. The direction can be clockwise or counter-clockwise. The robot
exits from the charging station and follows the wire in the indicated direction to reach the secondary area.
SECONDARY AREA 2: Function for defi ning the automatic mowing of secondary area number 2. This setting uses the same confi guration
parameters as those used for secondary area 1.
SECONDARY AREA 3: (only for some versions, see "Technical Specifi cations"). Function for defi ning the automatic mowing of secondary area
number 3. This setting uses the same confi guration parameters as those used for secondary area 1.
CHANGE PASSWORD: function for setting or changing the password.
-
No: the password entered does not need to be changed.
-
Yes: for entering or changing the password to be used for turning on the robot. You will prompted to enter the following information :
•
Password: Enter the old password (manufacturer's default 0000).
•
New password: Enter the new password.
•
Repeat password: Enter the new password again.
Important
To set or change the password, it is fi rst necessary to enter the previous one and then enter the new one. Upon purchase,
the password entered by the manufacturer consists of four numbers (0000).
Important
When entering the password, you will be prompted to re-enter the password in order to ensure that it has been set correctly.
In order to not forget the password, choose a number combination that is easy to remember.
START PASSWORD: This function allows defi ning whether you want to enter a password each time the robot is turned on after a period of
inactivity (e.g. winter storage).
-
No: There is no need to enter a password each time the robot is turned on. The robot requires the password to confi rm this parameter.
-
Yes: The password will be required each time the robot is started.
User's manual
SECONDARY AREAS – PROGRAMMING MODE
SAFETY – PROGRAMMING MODE
22
primary area
secondary area 1
(30%, 60MT, clokwise)
secondary area 2
(20%, 30MT, Anti-clokwise)
anti-clockwise direction
clockwise direction
Advertisement
Table of Contents
