Preparation And Marking The Boundaries Of The Work Areas - Stiga autoclip 920 s User Manual

The illustration provides some useful tips on how to correctly setup the
robot for a quick re-entry.

PREPARATION AND MARKING THE BOUNDARIES OF THE WORK AREAS

Preparation of the lawn to be mowed
1.
Make sure the lawn to be mowed is even and does not contain holes,
stones or other obstacles. If necessary, prepare the lawn by fi lling
in any holes and removing any obstacles. If some obstacles cannot
be removed, it is necessary to properly mark these areas with the
perimeter wire.
2.
Check that no areas of the lawn exceed the allowable slopes (see
"Technical Specifi cations"). When working on slopes, the wheels
may slip when the robot detects the wire, causing it to fall outside the
perimeter.
Important
Areas with slopes greater than those allowed cannot be
mowed with the robot. Therefore, position the perimeter
wire in front of the slope so that it is excluded from the
area to mow.
0-20%
OK
perimeter wire
35 %
35 cm
(13,78 ")
100 cm (39,3 ")
0-20%
OK
0-35%
4-10 mt.
5 cm.
4-10 mt. 2 mt.
OK
21-35%
NO
perimeter wire
40 cm
(15,75 ")
11
50
40 40
min. 150 cm.
(59,05 ")
2 mt.
step
lower 2,5 mt.
4-10 mt.
NO
21-35%
OK
NO
0-20%
User's manual
EN