Precautions - Sony MHC-GT3D Operating Instructions Manual

NOT USE
You tried to perform a specific
operation under conditions where that
operation is prohibited.
OVER CURRENT
An over current from the
was detected.
PROTECT
The USB device is write-protected.
PUSH STOP
You tried to perform an operation that
can be performed only when the
playback is stopped.
READING
The system is reading information of
the disc or USB device. Some
operations are not available.
REC ERROR
The transfer did not start, stopped
partway, or otherwise could not be
performed.
TIME NG
The on time and off time of Play Timer
or Recording Timer is the same.
TRACK FULL
You cannot transfer onto the USB
device because the number of file has
reached its maximum.

Precautions

When carrying the subwoofer
Perform the following procedure to
protect the disc mechanism.
Use the buttons on the subwoofer to
perform this operation.
1 Press  to turn on the system.
2
Press FUNCTION, then turn the
MULTI CONTROL knob to select
"DVD/CD", then press ENTER.
3
Remove the disc.
Press  to open and close the disc
tray.
Wait until "NO DISC" appears in the
display panel.
4
Unplug the AC power cord (mains
(USB) port
lead).
Notes on discs

Before playing, wipe the disc with a
cleaning cloth from the center outward
to the edge.

Do not clean discs with solvents, such as
benzine, thinner, or commercially
available cleaners or anti-static spray
intended for vinyl LPs.

Do not expose discs to direct sunlight or
heat sources such as hot air ducts, nor
leave it in a car parked in direct sunlight.
On safety

Completely disconnect the AC power
cord (mains lead) from the wall outlet
(mains) if it is not going to be used for an
extended period of time. When
unplugging the system, always grip the
plug. Never pull the cord itself.

Should any solid object or liquid get into
the system, unplug the system, and
have it checked by qualified personnel
before operating it again.

AC power cord (mains lead) must be
changed only at the qualified service
shop.
On placement

Do not place the system in an inclined
position or in locations that are
extremely hot, cold, dusty, dirty, or
humid or lacking adequate ventilation,
or subject to vibration, direct sunlight or
a bright light.

Be careful when placing the system on
surfaces that have been specially
treated (for example, wax, oil, polish) as
staining or discoloration of the surface
may result.

If the system is brought directly from a
cold to a warm location or is placed in a
very damp room, moisture may
condense on the lens inside the
subwoofer, and cause the system to
malfunction. In this situation, remove
the disc, and leave the system turned on
for about an hour until the moisture
evaporates.
59 GB