Sony MHC-GT3D Operating Instructions Manual page 16


Place the subwoofer at least 10 cm from
the wall to avoid damaging the
protruding AC power cord (mains lead).
Installing the speaker
system on a wall
Notes

Use screws that are suitable for the wall
material and strength. As a plaster
board wall is especially fragile, attach
the screws securely to a wall stud. Install
the speaker system on a vertical and flat
reinforced area of the wall.

Be sure to subcontract the installation to
Sony dealers or licensed contractors and
pay special attention to safety during
the installation.

Sony is not responsible for accidents or
damage caused by improper
installation, insufficient wall strength,
improper screw installation or natural
calamity, etc.
1
Prepare screws (not supplied) that
are suitable for the holes on the
back of the speaker system.
More than 25 mm
16 GB
10 cm
4 mm
Hole on the back of the speaker system
5 mm
10 mm
2
Drive the screws to the wall.
The screws should protrude 6 mm
to 7 mm from the wall.
6 mm to
7 mm
3
Hang the speaker system onto the
screws.
Align the holes on the back of the
speaker system to the screws, then
hang the speaker system onto the
2 screws.
800 mm