Installing The Speaker System On A Tripod - Sony MHC-GT3D Operating Instructions Manual

Installing the speaker
system on a tripod
Match the hole on the speaker system
() to the tripod (not supplied) (),
then gently push it downward until it is
inserted completely to the tripod.
Be sure to use tripod of approximately
35 mm in diameter only.
Height:
0.74 m to
1.4 m
More than
0.55 m*
* We recommend you to expand the
tripod legs to maximum.
Note
Take the following precautions when
installing the speaker system on the
tripod to avoid personal injury or
damaging the speaker system.
 Set up the tripod completely before you
install the speaker system. Be sure to
read the operating instructions of your
tripod.
 Do not install the speaker system on the
tripod placed on unstable surface,
walkway or any other unsuitable
locations.
 Make sure the speaker system is
attached on the tripod securely.
 Do not push the speaker system or
place any objects on the speaker
system when it is installed on the tripod.
18 GB
35 mm
 Do not rotate or lift the speaker system
when it is installed on the tripod.
 Do not walk over the tripod legs to
avoid from tripping.
 Disconnect the AC power cord (mains
lead) and all cables, and detach the
speaker system from the tripod when
you want to move the tripod, speaker
system or the subwoofer.
 Be careful not to trip over the speaker
cable, tripod legs or the AC power cord
(mains lead).
 Keep children away from the speaker
system installed on the tripod.
 Take other precautions to prevent the
speaker system installed on the tripod
from falling.