Precautions - Sony CMT-EP707 Operating Instructions Manual

On operating voltage
Before operating tile system, check that tile operating
voltage of your system is identical wilh the voltage of
your local power supply.
On safety
• The system is not disconnected from the AC power
source (mains) as long as it is connected to the wall
outlet, even if the system itself has been turned ofli
• Unplug the system from the wall outlet (mains) if it
is not to be used for an extended period of time. To
disconnect the cord (mains lead), pull it out by the
plug. Never pull the cord itselt]
• Should any solid object or liquid Pall into the
componenb unplug the stereo system and have the
component checked by qualified personnel before
operating it rely {hrther.
• The AC power cord mus_ be changed rally at a
qualified service shop.
• The nameplate is located on the bottom exteror.
On placement
• Place tile syslem in a location widl adequale
venrilatlon to prevent beat build-up tile system.
• Do not place the system in ml inclined position.
• Do not place the system in locations where it is;
Extremely hot or cold
Dusly or dirty
Very humid
Vibrating
Subject to direcl sunlighL
• Use caution when placing the unit or speakers on
surfaces that have been specially trealed (widl wax,
oil, i_ofish, etc.) as s_aining or discolorafion of the
surface may result.
On heat buildup
• Although tile system heals up during operation, this
is ]lot malfunction.
• Place tile syslem in a location widl adequale
venrilafion to prevent heat build-up in the syslem.
If you confint_ously use this syslem at a large volume,
the cabinet temperature of the top, side and bol_om
rises considerably. To avoid burning yourself, do no_
touch the cabinet.
To prevent a malfimction, do ]lot cover tile vemilafion
hole.
On operation
• If the system
is brought directly from a cold 1o a
warm location, or is placed in a very damp room,
illolslure may COlldellse on die lens inside the CD
player. Should Ibis occur, the system will not
operate properly. Remove the CD and leave the
system turned on for about an hour until the
moisture evaporates.
• When you move the system, take out any discs.
If you ]lave any questions or problems concerning
your stereo system, please consult your nearest Sony
dealer.
Notes on CDs
• Before playing, clean die CD with a cleaning cloth.
Wipe the CD b'om the ce_lter out.
• Do not use solvents.
• DO not expose the CD to direct sunlight or heat
sources.
• Discs with non-s_andard shapes (e.g., hear_, square,
star) cannot be played on this syslem. Al_empting to
do so may damage the system. Do no_ use such
discs.
Note on CD.R/CD-RW playback
Discs recorded on CD-R/CD-RW drives may not be
played back because of scralches, dirt., recording
condition or the drive's characteristics. Besides, the
discs, which are not yet finalized at the end of
recording cannot be played back.
Cleaning the cabinet
Use a sot_ clolh slightly moislened widl mild
de_ergen_ solution.
To save a tape permanently
TO prevent a t_pe from being accidentally recorded
over, break offthe cassette tab t¥om side A or B as
illustrated.
_ ___Break off the
Cassette tab of
side A
If you laler want to reuse the tape {'orrecording, cover
the broken tab with adhesive tape.
6'
=
w_
B
i
6'
continued
21GB