Use Remote Access - NETGEAR Nighthawk X4S R7800 User Manual

6. In the Allow Remote Access By section, specify the external IP addresses to be allowed to access the router's
remote management.
Note For enhanced security, restrict access to as few external IP addresses as practical.
Select one of the following:
• Only This Computer. Allow access from a single IP address on the Internet. Enter the IP address to be
allowed access.
• IP Address Range. Allow access from a range of IP addresses on the Internet. Enter a beginning IP address
and an ending IP address to define the allowed range.
• Everyone. Allow access from any IP address on the Internet.
7. Specify the port number for accessing the web management interface.
Normal web browser access uses the standard HTTP service port 80. For greater security, enter a custom port
number for the remote web management interface. Choose a number from 1024 to 65535, but do not use the
number of any common service port. The default is 8080, which is a common alternate for HTTP.
8. Click the Apply button.
Your settings are saved.

Use Remote Access

To use remote access:
1. Launch a web browser on a computer that is not on your home network.
2. Type your router's WAN IP address into your browser's address or location field followed by a colon (:) and the
custom port number.
For example, if your external address is 134.177.0.123 and you use port number 8080, enter
http://134.177.0.123:8080 in your browser.
Nighthawk X4S AC2600 Smart WiFi Router
Manage Your Network
96