Specify The Ip Addresses That The Router Assigns - NETGEAR Nighthawk X4S R7800 User Manual

a. Select a RIP direction:
• Both. The router broadcasts its routing table periodically and incorporates information that it receives.
• Out Only. The router broadcasts its routing table periodically.
• In Only. The router incorporates the RIP information that it receives.
b. Select a RIP version:
• Disabled. This is the default setting.
• RIP-1. This format is universally supported. It is adequate for most networks, unless you are using an
unusual network setup.
• RIP-2. This format carries more information. Both RIP-2B and RIP-2M send the routing data in RIP-2
format. RIP-2B uses subnet broadcasting. RIP-2M uses multicasting.
8. Click the Apply button.
Your changes are saved.
If you changed the LAN IP address of the router, you are disconnected when this change takes effect.
9. To reconnect, close your browser, relaunch it, and log in to the router

Specify the IP Addresses That the Router Assigns

By default, the router acts as a Dynamic Host Configuration Protocol (DHCP) server. The router assigns IP, DNS
server, and default gateway addresses to all computers connected to the LAN. The assigned default gateway address
is the LAN address of the router.
These addresses must be part of the same IP address subnet as the router's LAN IP address. Using the default
addressing scheme, define a range between 192.168.1.2 and 192.168.1.254, although you can save part of the
range for devices with fixed addresses.
To specify the pool of IP addresses that the router assigns:
1. Launch a web browser from a computer or wireless device that is connected to the network.
2. Type http://www.routerlogin.net.
A login window opens.
3. Enter the router user name and password.
The user name is admin. The default password is password. The user name and password are case-sensitive.
The BASIC Home page displays.
Nighthawk X4S AC2600 Smart WiFi Router
Network Settings
53