Turntable Motor Replacement - Sharp R-895(AL)M Service Manual

COMPONENT REPLACEMENT AND ADJUSTMENT PROCEDURE
Coil
Stator
Gap
Rotor
Bracket
Removal
2. Remove the turntable from the oven cavity.
3. Turn the oven over.
4. Cut the four (4) bridges holding the turntable motor
cover to the base plate with cutting pliers as shown in
Figure C-2(a).
CAUTION: DO NOT DROP THE TURNTABLE MOTOR
COVER INTO THE OVEN AFTER CUTTING
THE BRIDGES. BECAUSE IT WILL DAM-
AGE THE WIRE LEADS OF THE MOTOR
AND IT IS DIFFICULT TO REMOVE IT OUT
OF THE OVEN.
5. Remove the turntable motor cover from the base plate.
6. Disconnect the wire leads from the turntable motor.
7. Remove the one (1) screw holding the turntable motor
to the turntable motor angle.
8. Bend the turntable motor retaining tab back to release
Bridges
Figure C-1(a). Turntable motor cover removal
1. CARRY OUT 3D CHECKS.
2. Push the lever of positive lock
3. Pull down on the positive lock
CAUTION: WHEN YOU (SERVICE ENGINEERS) CON-
NECT THE POSITIVE LOCK
TORS TO THE TERMINALS, CONNECT
THE POSITIVE LOCK
VER FACES YOU.
Groove joint pliers
Shaft
Axis
Stator

TURNTABLE MOTOR REPLACEMENT

Cutting pliers
Bridges
Turntable motor
cover
POSITIVE LOCK
® connector.
® connector.
® CONNEC-
® SO THAT THE LE-
These are the positions
that should be pinched
with pliers.
Rotor
the motor.
9. Remove the turntable motor from the turntable motor
angle. Now, the turntable motor is free.
Re-install
1. Remove the any sharp edges on the turntable motor
cover and the base plate with the cutting pliers.
2. Re-install turntable motor by locating shaft onto turnta-
ble motor shaft to the turntable motor angle with the one
(1) screw.
3. Bend the turntable motor retaining tab forward to se-
cure the motor.
4. Re-connect the wire leads to the turntable motor.
5. Insert the two (2) tabs of the turntable motor cover into
the slits of the base plate as shown in Figure C-2(b).
6. Re-install the turntable motor cover to the base plate
with the screw (LX-EZA045WRE0) as shown in Figure
C-2(b).
Turntable motor cover
Figure C-1(b). Turntable motor cover re-install
®
CONNECTOR REMOVAL
Figure C-2. Positive lock
R-895M - 26
Table
Screw;
LX-EZA045WRE0
Tabs
Slits
Base plate
Positive lock¤
connector
Lever
®
Shaft
Center of
bracket
Terminal
1
Push
2
Pull down
connector