Hp-Gl/2 Problems - Canon iPF850 series Basic Manual

iPF850 Series

HP-GL/2 problems

HP-GL/2 problems
With HP-GL/2, printing is misaligned ............................................................................................................. 135
Lines or images are missing in printed HP-GL/2 jobs. ................................................................................... 135
Lines are printed too thick or thin in HP-GL/2 print jobs ................................................................................ 135
HP-GL/2 jobs are printed in monochrome (or color) ...................................................................................... 136
Printed colors of lines are inaccurate during HP-GL/2 printing ....................................................................... 136
HP-GL/2 jobs are printed 6 mm larger than specified .................................................................................... 136
HP-GL/2 jobs are printed at maximum size, even if a standard size is specified ............................................. 136
HP-GL/2 printing takes a long time ............................................................................................................... 136
The printer stops when printing a HP-GL/2 job (the carriage stops moving) ................................................... 136
With HP-GL/2, printing is misaligned
With HP-GL/2, printing is misaligned
Cause
The plotter origin is incorrect.
The Margin setting in the Control Panel
menu is incorrect.
Lines or images are missing in printed HP-GL/2 jobs.
Lines or images are missing in printed HP-GL/2 jobs.
Cause
The memory is full.
An HP-GL/2 command not supported by this printer
was received.
The printer has received print data that includes HP
RTL commands when Auto Rotate is On in the
Control Panel menu.
The plotter origin is incorrect.
Oversize in the Control Panel menu is set to Off.
Lines are printed too thick or thin in HP-GL/2 print jobs
Lines are printed too thick or thin in HP-GL/2 print jobs
Cause
The Width setting in the Control Panel
menu is incorrect.
ThickenFineLines in the Control Panel
menu is set to Off.
The Ln wdth correct setting in the Con-
trol Panel menu is incorrect.
Basic Guide
Check the printing commands.
Set Detect img size to Command priority or Detected size in the Control Panel
menu.
(See "Menu Settings.")
User's Guide
➔
Adjust the Margin setting values in the Control Panel menu.
(See "Menu Settings.")
User's Guide
➔
Check the size of the data in the print job.
Check the print job and settings.
In the Control Panel, set Auto Rotate to Off and print again.
(See "Menu Settings.")
Set Detect img size to Command priority or Detected size in the Control
Panel menu.
(See "Menu Settings.")
Set Oversize to On in the Control Panel menu.
(See "Menu Settings.")
Change the Width setting configured in Pen no. of the Palette A or Palette B selected
in the Control Panel menu.
(See "Menu Settings.") User's Guide
➔
If fine lines are printed faintly, setting ThickenFineLines to On will print the lines more
distinctly.
(See "Menu Settings.") User's Guide
➔
Change the Ln wdth correct setting in the Control Panel menu.
(See "Menu Settings.")
User's Guide
➔
With HP-GL/2, printing is misaligned
Corrective Action
Corrective Action
User's Guide
➔
User's Guide
➔
User's Guide
➔
Corrective Action
135