Roll Paper Cannot Be Inserted Into The Paper Feed Slot; Cannot Load Sheets; Paper Is Not Cut Neatly; The Size Of Clear Film Cannot Be Detected - Canon iPF850 series Basic Manual

Roll paper cannot be inserted into the Paper Feed Slot

Roll paper cannot be inserted into the Paper Feed Slot
Roll paper cannot be inserted into the Paper Feed Slot
The roll paper is warped.
Paper is jammed by the paper feed slot.
The paper source selection is incorrect.
If paper cannot be advanced from Roll 2 (Lower),
the Roll Unit Cable is disconnected.

Cannot load sheets

Cannot load sheets
Cause
The paper source selection is incorrect.

Paper is not cut neatly

Paper is not cut neatly
The paper is bent or curled at the cut posi-
tion.
Paper rises by the ends of the cut position
before it is cut.
You are using paper that cannot be cut with
the Cutter Unit.
Cut Speed is not configured correctly in the
Control Panel menu.
During cutting, printed documents fall out at
an angle.
Paper is not cut
Paper is not cut
In the printer driver, No or Print Cut Guideline is specified
in Automatic Cutting.
In the Control Panel menu, Cutting Mode is set to Eject
or Manual.
The Stacker continues to rotate
The Stacker continues to rotate
The paper is not fed into the Stacker from the printer because of a paper jam, etc.

The size of clear film cannot be detected

The size of clear film cannot be detected
The Platen is soiled with ink or other substances.
122
Cause
Press the Load button and select the paper source.
Cause
Straighten out any curling by the edges of the paper.
Reload the paper correctly.
Specify Manual in Cutting Mode in the Control Panel menu and use scissors or a
cutting tool to cut the roll after printing.
(See "Specifying the Cutting Method for Rolls.")
Change the Cut Speed setting in the Control Panel menu.
(See "Menu Structure.")
In the Control Panel menu, set Cutting Mode to Eject. Hold documents after print-
ing, as they are cut.
(See "Specifying the Cutting Method for Rolls.")
Cause
Cause
Cause
Straighten out curls and reload the roll.
Remove the jammed paper.
(See "Clearing Jammed Roll Paper.")
(See "Clearing a Jammed Sheet.")
Press the Load button and select the paper source.
Connect the Roll Unit Cable firmly to the Roll Unit Power Supply Inlet and the
inlet on the roll unit.
Corrective Action
P.72
➔
Specify Yes in Automatic Cutting in the printer driver.
(See "Page Setup Sheet (Windows).")
(See "Paper Detailed Settings Dialog Box (Mac OS).")
If the Cutting Mode is Eject, press the Cut button to cut the paper.
If the Cutting Mode is Manual, cut rolls with scissors or the like.
(See "Specifying the Cutting Method for Rolls.")
Corrective Action
Open the Top Cover and clean the entire Platen.
(See "Cleaning Inside the Top Cover.")
Corrective Action
P.111
➔
P.114
➔
Corrective Action
User's Guide
➔
User's Guide
➔
Corrective Action
User's Guide
➔
➔
Corrective Action
Turn the Stacker power switch off.
P.59
➔
iPF850 Series
User's Guide
➔
User's Guide
Basic Guide