Call Intercept; Temporarily Turning Off The Message Alert Tone - AT&T EL52200 User Manual

Answering system operation
Answering system overview

Call intercept

While call screening, you can press
SPEAKER on the handset to stop recording and speak
to the caller.

Temporarily turning off the message alert tone

Follow the step below to temporarily silence the message alert tone:
• When the telephone base is in idle mode, press any
telephone base key (except
The message alert tone is activated again with the next
incoming message.
NOTES:
• When the telephone base is in idle mode, if you press
to temporarily silence the message alert tone, there is a voice prompt to direct you to
DELETE again to delete all old messages (see To delete all old messages at the
press
telephone base on page 48). If you are not going to delete all old messages, wait at least 5
seconds to allow the telephone base to return to idle mode.
• To turn off the message alert tone, see Message alert tone on page 42.
PHONE/
FLASH
HANDSET LOCATOR).
45
or
DELETE