Lamp Power; Remote Control; Security - Panasonic PT-CW230EA Operating Instructions Manual

Part of characters may not displayed when high
compensation values are set in [Keystone].
Closed captions are not displayed while the menu screen
appears.

Lamp power

This function allows you to change brightness of the
screen.
1 ) Press ▲▼ to select [Lamp power] and
then press the <SELECT> button .
2 ) Press ▲▼ to select one among the
modes as below.
You can also press the <LAMP> button to
display [Lamp power].
Normal Normal brightness.
Lower brightness reduces the
Eco lamp power consumption and
extends the lamp life.

Remote control

This switching function prevents remote control
interference when operating several projectors or
video equipment at the same time.
1 ) Press ▲▼ to select [Remote control].
2 ) Press ► or the <SELECT> button.
3 ) Press ▲▼ to select one among the
two codes.
This projector provides 2 different remote
control codes: [Code 1] and [Code 2].
Attention
When different codes are set on the projector and on the
remote control, any operation cannot be made. In that
case, switch the code on the remote control to fit the
code on the projector.
If the batteries are removed from the remote control for a
long period of time, the remote control code will be reset.

Security

This function allows you to use the Key lock and PIN
code lock function to set the security for the projector
operation.
1 ) Press ▲▼ to select [Security].
2 ) Press ► or the <SELECT> button to
access the submenu.
Key lock
This function locks the control panel and remote
control buttons to prevent operation by unauthorized
persons.
1 ) Press ▲▼ to select the desired items
as below.
Unlocked.
Lock the operation of the control
panel. To unlock, use the remote
control.
Lock the operation of the remote
control. To unlock, use the control
panel.
PIN code lock
This function prevents the projector from being
operated by unauthorized persons and provides the
following setting options for security.
1 ) Press ▲▼ to select the desired items
as below.
Off Unlocked.
Enter the PIN code every time
On1
turning on the projector.
Enter the PIN code to operate
the projector once the power cord
is disconnected; as long as the
On2
AC power cord is connected, the
projector can be operated without
a PIN code.
Attention
Whenever you change the PIN code lock setting or the
PIN code (the four-digit number), you are required to
enter the PIN code. The "1234" is set as the initial PIN
code at the factory.
Setting
57
ENGLISH -