Screen; Screen [ ]; Normal; Full - Panasonic PT-CW230EA Operating Instructions Manual

Screen

Select [Screen] from the Main Menu (see
"Navigating through the menu" on page 37),
then select the item from the sub-menu.
Remote Control

Normal

Provide the image to fit the screen size while
maintaining the aspect ratio of the input signal.
Press ▲▼ to select [Normal] and then
press the <SELECT> button.

Full

Provide the full screen image.
Press ▲▼ to select [Full] and then press
the <SELECT> button.

Wide(16:9)

Provide the image at the 16:9 wide screen ratio.
Press ▲▼ to select [Wide(16:9)] and then
press the <SELECT> button.

Zoom

Scale the image proportionally to fit the entire screen.
Either side of image may go over the screen.
Press ▲▼ to select [Zoom] and then
press the <SELECT> button.
Control Panel

True

Provide the image in its original size. When the
original image size is larger or smaller than the panel
*
size (1280 x 800), the projector enters to the panning
mode automatically.
1 ) Press ▲▼ to select [True] and then
press the <SELECT> button.
2 ) Press ▲▼◄► to pan the image.
When adjusted, the arrows will turn red. When
reached to the correction limits, the arrows will
disappear.
*
Screen size (1280 x 800) is only for PT-CW230EA.
Screen size (1024 x 768) is for PT-CX200EA.
Note
When input computer signal to the projector, [True] will
be available.
[True] is disabled and cannot be displayed when [480i],
[576i], [480p], [576p], [720p] or [1080i] is selected in the
PC System Menu.
When [True] is selected in the Screen menu, [Digital
zoom +/-] can not be selected

Natural wide

(PT-CW230EA Only)
Modify the 4:3 aspect ratio image to fit the screen size
by stretching the image to make it look natural.
Press ▲▼ to select [Natural wide] and
then press the <SELECT> button.
Note
When input video signal to the projector, [Natural wide]
will be available.
[Natural wide] is not available when [720p] or [1080i] is
selected in the PC System Menu.

Custom

Provide the last stored aspect screen image.
Press ▲▼ to select [Custom] and press
the <SELECT> button.
.
ENGLISH -
49