Table of Contents
Advertisement
Setting
Execute
J
1 )
Press ▲▼ to select one among the
items as below and then press the
<ENTER> button.
Start
It executes the count up or count
down function.*
Reset
Reset the P-timer values.*
Exit
To exit the P-timer operation.
*1 :
Press the <ENTER> button at Start and the
indication changes into Stop. To stop Count up or
Count down, press the <ENTER> button at Stop
on the screen menu, then the indication changes
into Restart. Press the <ENTER> button at
Restart to resume Count up or Count down.
*2 :
Press the <ENTER> button at Reset to return to
the following value:
Count up
Count down
Attention
To stop the [P-timer] function, press the <P-TIMER>
z
button.
To cancel the [P-timer], press and hold the <P-TIMER>
z
button for a few seconds.
Closed caption
[Only for NTSC, 480i input]
1 )
Press ▲▼ to select [Closed caption].
2 )
Press ► or the <ENTER> button to
enter the submenu.
Closed caption
J
1 )
Press ▲▼ to select [Closed caption]
and then press the <ENTER> button.
2 )
Press ▲▼ to select [Off], [CC1], [CC2],
[CC3] or [CC4].
Color
J
1 )
Press ▲▼ to select [Color] and then
press the <ENTER> button.
2 )
Press▲▼ to select [Color] or [White].
Attention
The closed caption is mainly used in the north America.
z
This function shows the text information contained in the
image signal. Captions may not be displayed on some
devices or software.
60
- ENGLISH
1
2
"000:00"
Timer that you set
You can select [Closed caption] when [NTSC] or [480i]
z
signals are input.
Part of characters may not displayed when high
z
compensation values are set in [Keystone].
Closed captions are not displayed while the menu screen
z
appears.
Lamp power
This function allows you to change brightness of the
screen.
1 )
Press ▲▼ to select [Lamp power] and
then press the <ENTER> button .
2 )
Press ▲▼ to select one among the
modes as below.
You can also press the <LAMP> button to
z
display [Lamp power].
Normal Normal brightness.
Lower brightness reduces the
Eco
lamp power consumption and
extends the lamp life.
Note
If [Lamp power] is set to [Normal] and the operating
z
environment temperature exceeds 35°C(95 °F), [Lamp
power] may be changed to [Eco] automatically.
Remote control
This switching function prevents remote control
interference when operating several projectors or
video equipment at the same time.
1 )
Press ▲▼ to select [Remote control].
2 )
Press ► or the <ENTER> button.
3 )
Press ▲▼ to select one among the
seven codes.
This projector provides 7 different remote
z
control codes: [ALL], [Code 1]~[Code 6].
Attention
When operating the projector under [ALL] code, you can
z
operate several projectors at the same time. If you want
to operate the projector independently, you must switch
to other code.
When different codes are set on the projector and on the
z
remote control, any operation cannot be made. In that
case, switch the code on the remote control to fit the
code on the projector.
If the batteries are removed from the remote control for a
z
long period of time, the remote control code will be reset.
Advertisement
Chapters
Table of Contents
