Replacing The Lamp Unit; Resetting The Lamp Runtime - Panasonic PT-CW230EA Operating Instructions Manual

Replacing the Lamp unit

CAUTION:
When the projector is mounted on a ceiling, do not work with your face close to the projector.
Attach the lamp unit and the lamp cover securely.
When you experience difficulty in installing the lamp, remove it and try again. If you use force to install the
lamp, the connector may be damaged.
1 ) Turn off the Power by following the
procedure in "Turning off the projector"
( page 30). Unplug the AC power cord.
Wait at least 1 hour and make sure
the lamp unit and surroundings are cool.
2 ) Use a Phillips screwdriver to loosen the
lamp cover fixing screw and open the
lamp cover.
Open the lamp cover by pulling it slowly
toward the direction of the arrow.
3 ) Use a Phillips screwdriver to loosen
the two lamp unit fixing screws until
the screws turn freely. Hold the used
lamp unit by its handles, and pull it
gently from the projector.
4 ) Insert the new lamp unit in correct
direction. Tighten the two lamp unit
fixing screws securely with a Phillips
screwdriver.
5 ) Close the lamp cover, and tighten the lamp cover fixing screw securely with a
Phillips screwdriver.
Close the lamp cover by pushing it slowly opposite the direction of the arrow.

Resetting the Lamp Runtime

Be sure to reset the [Lamp runtime] after replacing the lamp. ( page 58 " Lamp runtime reset") "
Replacement
Lamp unit fixing screws
Lamp cover
Lamp cover
fixing screw
Lamp unit
Handles
65
ENGLISH -