Turning On The Projector - Panasonic PT-CW230EA Operating Instructions Manual

Powering ON/OFF

Turning On the Projector

1 ) Complete peripheral connections (with a
computer, VCR, etc.) before turning on the
projector.
2 ) Connect the projector's AC power cord into an
AC outlet. The <ON(G)/STANDBY(R)> indicator
lights red.
3 ) Press the <
the remote control. The <ON(G)/STANDBY(R)>
indicator lights green and the cooling fans start
to operate. The preparation display appears on
the screen and the count down starts.
4 ) After the countdown, the input source that was
selected the last time and the lamp power status
icon appear on the screen.
5 ) If there is no signal input when start on the
projector, or the current signal is missed while
operating the projector, the Video/Computer
selection window will be displayed on the screen,
please move the pointer to input source desired
by pressing the ▲▼ and the <SELECT> button.
And then follow the input signal guidance window
to correct the signal and connection.
If the projector is locked with a PIN code, PIN
code input dialog box will appear. Enter the PIN
code as instructed on the next page.
Note
When the [Logo select] function is set to [Off], the logo
will not be shown on the screen (
When [Countdown off] or [Off] is selected in the [Display]
function, the preparation display will not be shown on the
screen ( page 54).
When the [Input search] function is set to [On 2], the
input signal will be searched automatically (
When the [Direct on] function is set to [On], the projector
will be turned on automatically by connecting the AC
power cord to an AC outlet.
28
- ENGLISH
(2)
> button on the control panel or
page 55).
page 53).
(3)
The preparation display will disappear
after 30 seconds
Selected Input Source and Lamp power
Video/Computer selection
06
.
Lamp power status
(3)