DAELIM S2 125 Service Manual page 79

A.C GENERATOR/STARTER CLUTCH
SETTING SCREW
8-2
LH. SHROUD
A.C.G WIRING
COUPLER
COOLING FAN
SHROUD
REMOVAL
● Remove the following parts.
-Luggage box (⇨3-2 )
-Center cover (⇨3-3 )
-Engine (⇨6-2 )
● Loosen the RH. shroud 4 flange bolts and 4 tapping
screws.
● Remove the RH. shroud.
● Loosen the LH. shroud setting screw.
● Remove the LH. shroud.
● Install in the reverse order of removal.
·Before removing the RH. shroud, be sure to remove
the RH. floor side cover and rear cushion upper bolt.
A.C GENERATOR
REMOVAL
● Loosen the rear cushion under bolt.
● Remove the following parts.
-Luggage box
(⇨3-2)
-Body cover (⇨3-4 )
-Center cover (⇨3-3 )
-Engine (⇨6-2 )
-RH. shroud comp (⇨8-2 )
● Remove the A.C.G wiring coupler and connector
connected to the wire harness.
● Remove the A.C.G wiring from the A.C.G wiring
setting clamp securing the engine and frame.
● Loosen the 3 cooling fan bolts.