Engine Removal/Installation - DAELIM S2 125 Service Manual

6. ENGINE REMOVAL/INSTALLATION

INFORMATION· · · · · · · · · · 6-1
SERVICE
ENGINE REMOVAL · · · · · · · · · · · · · · · · 6-2
SERVICE INFORMATION
GENERAL SAFETY
•Use a jack to remove or install the engine. Support the motorcycle with a jack firmly, taking precautions not to
damage the frame, engine, cable or harness.
•Attach tape to the frame to protect it during the engine removal or installation.
● The following works can be carried out without removing the engine from the vehicle body.
-TRANSMISSION (⇨SECTION 11)
-STARTING CLUTCH (⇨SECTION 8)
-OIL PUMP (⇨SECTION 4)
-A.C. GENERATOR (⇨SECTION 8)
-STARTER MOTOR (⇨SECTION 16)
-CONTINUOUSLY VARIABLE TRANSMISSION (⇨SECTION 7)
-CYLINDER HEAD/ CYLINDER/ PISTON (⇨SECTION 9,10)
-EX. MUFFLER (⇨SECTION 3)
-CARBURETOR (⇨SECTION 5)
-REAR SWING ARM (⇨SECTION 13)
● Items to be worked after removing engine.
-CRANKSHAFT, CRANKSHAFT BEARING, CRANK CASE BEARING
● Engine oil capacity : 1.1ℓ- when disassembled.
TORQUE VALUES :
ENGINE HANGER BOLT (FRONT) : 2.7㎏f·m
(REAR) : 3.5㎏f·m
6
6-1