Electrical Installation; Electrical Wiring; Remote Wall Mounted Switch - Monessen Hearth IDV SERIES IDV380NVC Installation And Operating Instructions Manual

Idv series direct vent gas fireplace insert

Hide thumbs

Table Of Contents

Table of Contents

IDV380/IDV490 Fireplace Insert

eleCtRiCAl WiRiNG

This insert will work without any electrical supply. Electricity is only needed to operate blower.

electrical connections should only be performed by a qualified, licensed electrician. Main power

must be off when connecting to main electrical power supply or performing service. All wiring

shall be in compliance with all local, city and state codes. the appliance, when installed, must

be electrically grounded in accordance with local codes, or in the absence of local codes, with

the National Electrical Code ANSI/NFPA 70 (latest edition) and Canadian Electrical Code, CSA

C22.1.

label all wires before disconnecting when servic-

ing controls. Wiring errors can cause improper and

dangerous operation.

Verify proper operation after servicing.

ReMOte WAll MOuNteD SWitCh

A remote wall switch and up to fifteen (15) feet of 18 Ga. wire may be used with this appliance. At-

tach the wall switch in a junction box at the desired location on the wall. Figure 18.

NOte: extended lengths of wire may cause the fireplace not to function properly. longer

length of wire is permitted if the wire is made out of larger gauge (diameter) wire. Always

check with local code.

Sparker

Thermocouple

Piezo Igniter

PILOT

Millivolt

Valve

Thermopile

Pilot Assembly

Switch

TH/TP

Figure 17 -

Wiring Diagram for Wall Switch

FP1933

wall switch wiring

OFF