Xerox PHASER 3124 Service Manual page 32

Status Indicator RAPs
8 LED blinking fault RAP
8A Fuser error
Switch off the electricity to the machine. Disconnect the power cord from the customer supply
while performing tasks that do not need electricity. Electricity can cause death or injury. Moving
parts can cause injury.
Description
All the LEDs on the operator panel are blinking.
Check and Cause
1. The fuser gear, PL 3 has melted
2.The thermistor, PL 3 is damaged
3. The halogen lamp, PL 3 may be defective.
4.The thermostat, PL 3 is damaged.
8B Scan error
Switch off the electricity to the machine. Disconnect the power cord from the customer supply
while performing tasks that do not need electricity. Electricity can cause death or injury. Moving
parts can cause injury.
Description
1. All LED's on the OPE panel are blinking.
Check and Cause
1. The LSU may be defective, PL 1.
2-12
WARNING
1. Refer to RAP 9.
2. Check and install a new thermistor, PL 3 if
necessary.
3.Check and install a new halogen lamp, PL 3
if necessary.
4. Check and install new parts as necessary:
• Thermostat, PL 3
• Fuser assembly, PL 1
WARNING
1. Check and install a new LSU, PL 1 if nec-
essary.
09/06
Solution
Solution
PHASER 3124 / PHASER 3125