Sanyo FWZV475F Owner's Manual page 33

To stop the timer recording in progress
1) Press [C] on the remote control.
2) Confirmation message will appear. Select "Yes",
then press [OK].
To stop the timer recording immediately, press
•
[ C ] on the unit.
Checking, canceling or correcting the timer
programming information
1) Press [TIMER SET].
2) Press [TIMER].
3) Check the information.
Timer Programming
JAN/30/15 12:00 AM L1 SP
SP (1:00)
Date Start
JAN/30 12:00AM 1:00AM
New Program
4a) To delete the timer program:
1 Use [K / L] to select the program you want to
delete, then press [OK].
2 Use [K / L] to select "Delete", then press [OK].
Confirmation window will appear.
3 Use [K / L] to select "Yes", then press [OK].
4b) To correct the timer program:
1 Use [K / L] to select the program you want to
correct, then press [OK].
2 Use [K / L] to select "Program Change", then
press [OK].
3 Correct the timer program by using
[K / L / { / B], then press [OK].
5) Press [TIMER] to exit.
6) Press [TIMER SET] to return to the timer standby
mode.
Note
Press [TIMER] to check the timer recording in progress.
•
When the timer recording is proceeding, that
program will be highlighted with red. In this case, you
cannot select any other program.
TIMER RECORDING
THU JAN/29 11:00AM
End L1/L2
L1
1/1
If the timer program did not complete
correctly, the error number appears in the
timer programming list.
Timer Programming
Date
E41 JAN/30
Each error number means:
E1-22 Recording error other than below
E37-39
E23-24 Unrecordable disc
E25-28 Copy prohibited program
E29 Disc protected
E30 Disc full
E31-32 Already 99 titles recorded
E33 Already 999 chapters recorded
E34 No space for Control information
1
E35 PCA full *
E36 Already finalized video format disc
E40 Some portion has not been recorded because of program
overlapping. Recording did not start at the start time.
E41 Power failed
E42 No disc when recording
A program with the error number is grayed in the timer
•
programming list.
Timer program with an error number will be cleared
•
once the entry screen for the program is displayed.
1
* PCA is a disc's space reserved for recording test.
FRI JAN/30 11:00AM
Start End L1/L2
12:00AM 1:00AM L1
New Program
1/1
EN EN 33 33