Specifying A Relay Station For Sending ([F-Code Tx]); Relay Distribution; Operation Flow - Konica Minolta bizhub C3850 User Manual

4.6

Specifying a relay station for sending ([F-Code TX])

4.6 Specifying a relay station for sending ([F-Code TX])

Relay distribution

The Relay Distribution function sends a fax to a relay station, which distributes the received fax to a pre-reg-
istered group of destinations.
If you have created groups of a relay station and the other destinations by area, you can reduce the total com-
munication cost compared to the cost of broadcasting to all destinations. This function is useful when broad-
casting faxes to distant locations.
Tips
-
The destination machine (relay station) must have the F-code function.
-
This machine supports the function (relay distribution request) to send a fax to a relay station. This ma-
chine does not support the function (relay distribution) to use this machine as a relay station.
- You need to check the registration number of the relay folder assigned to the relay station and the pass-
word for relay distribution in advance.
- This function cannot be used together with the following functions:
Password TX, Polling TX, Polling RX
Related setting (for the administrator)
You can specify whether or not to use the F-Code TX function.
To configure settings: [Utility] - [Administrator Settings] - [Fax Settings] - [Function Settings] - [Function
ON/OFF Setting] - [F-Code TX] (default: [ON])

Operation flow

1
Load the original.
2
Tap [Fax].
3
Specify the fax number of the relay station.
4
Tap [Application] - [Fax Setting] - [F-Code TX], then tap [ON].
5
Enter the [Sub Address] and [Password], then tap [OK].
% [Sub Address]: Enter the registration number of the relay folder.
% [Password]: Enter the password for the relay distribution.
6
Press the Start key.
This starts the fax transmission to the relay station. Faxes received by a relay station are delivered to
destinations registered with the relay station.
[Fax Functions]
4
4-7