Briggs & Stratton 272147 Repair Manual page 73

• The inside band of the mounting bracket has
locating tabs that fit into notches in the air
cleaner housing.
This allows the air cleaner housing to be rotated in a
number of positions in case of clearance concerns in
certain equipment applications.
Fig. 176
1. Assemble mounting bracket to air cleaner housing
with front mounting hole
, Fig. 177.
2. Rotate air cleaner housing so that base of
mounting bracket is parallel to air inlet tube.
Fig. 177
3. Assemble air cleaner housing and mounting
bracket to engine and install front mounting
Page 68
towards air inlet side
TM
Vanguard Twin-Cylinder OHV Liquid-Cooled Engine
screw, Fig. 178. Torque front screw to
.
(10 Nm)
Fig. 178
4. Install rear mounting screw
5. Push on rear mounting bracket to eliminate any
slack in mounting bracket. Hold in this position,
Fig. 179. Torque rear screw to
Fig. 179
6. Assemble air cleaner cartridge air outlet tube in air
cleaner housing. Push cartridge onto tube as far
as it will go.
7. Install intake elbow tube.
Section 5 - Engine Assembly
90 in. lbs.
loosely.
90 in. lbs. (10 Nm)
.