NOTE
: Lip
on spacer must face bearing in
drive end cap.
Fig. 113
Assemble Starter
1. Assemble drive lever to pinion and install
armature and drive lever into drive housing, Fig.
114.
PINION
Fig. 114
2. Align tab on drive lever with notch in housing, Fig.
48.
Page 50
Fig. 115
DRIVE LEVER
DRIVE HOUSING
Fig. 116
TM
Vanguard
Twin-Cylinder OHV Liquid-Cooled Engine
3. Assemble starter housing to drive housing,
aligning notch 115.
4. Install brush holder, inserting tabs on brush holder
into slots in starter housing, Fig. 116.
BRUSH
HOLDER
TABS
SLOTS
SLOTS
5. Insert brushes into brush holder, Fig. 117.
Section 4 - Engine Overhaul
NOTCH
TAB
BRUSH
HOLDER
TABS
SLOTS