Using The Scsiselect Utility Program; Starting The Scsiselect Utility Program - IBM Netfinity 7100 User's Reference Manual

Power-on password
Administrator
password
Administrator and
power-on password
Table 2. Power-on and administrator password features

Using the SCSISelect utility program

SCSISelect is a built-in, menu-driven configuration utility program that you can use to:
The following sections provide the instructions needed to start the SCSISelect Utility
and descriptions of the menu choices available.
Note: If your server has a RAID adapter installed, use the configuration method sup-

Starting the SCSISelect utility program

To start the SCSISelect utility program:
1. Turn on the server.
2. When the <<< Press <CTRL><A> for SCSISelect™ Utility! >>> prompt appears,
3. When prompted, select either channel A or channel B.
4. Use the arrow keys to select a choice from the menu.
5. Follow the instructions on the screen to change the settings of the selected items;
Type of password
• Enter the password to complete the system startup.
• All choices are available on the Configuration/Setup Utility
• No password is required to start the system.
• Enter the password to access the Configuration/Setup Utility
• All choices are available on the Configuration/Setup Utility
• You can enter either password to complete the system
• The administrator password provides access to all choices
• The power-on password provides access to a limited set of
• View the default SCSI IDs
• Locate and correct configuration conflicts
• Perform a low-level format on a SCSI hard disk
plied with the RAID adapter to view or change SCSI settings for attached
devices.
press Ctrl+A.
Note: If an administrator password has been set, a prompt appears asking you to
enter the password to start the SCSISelect Utility program.
• Press Esc to return to the previous menu.
• Press the F5 key to switch between color and monochrome modes (if your
monitor permits).
then, press Enter.
Results
main menu.
program.
main menu.
startup.
on the Configuration/Setup Utility main menu. You can set,
change, or delete both the administrator and power-on
passwords, and allow a power-on password to be changed
by the user.
choices on the Configuration/Setup Utility main menu. This
limited access might include changing or deleting the power-
on password.
Chapter 3. Configuring your server
17