Ethernet Controller Messages; Messages - IBM Netfinity 7100 User's Reference Manual

Ethernet controller messages

The integrated Ethernet controller might display messages from the following device
drivers:
Novell NetWare or IntraNetWare server ODI driver messages
This section provides explanations of the error messages for the Novell NetWare or
IntraNetWare server ODI driver, and suggested actions to resolve each problem.
PCNTNW-NW-026 The MSM is unable to parse a required custom keyword.
Explanation: The user entered an incorrect parameter keyword.
Action: Reload the driver using the correct keyword.
PCNTNW-NW-054 The adapter did not respond to the initialization command.
Explanation: The adapter did not respond when the driver tried to initialize it.
Action: Verify that the Ethernet controller is enabled. If the Ethernet controller is enabled, go
to "Starting the diagnostic programs" on page 123 to run the diagnostic programs.
PCNTNW-NW-058 The adapter did not respond to the initialization command.
Explanation: The interrupt request (IRQ) setting might not be valid or the EEPROM
information might be incorrect.
Action: Make sure the IRQ settings are correct in the Configuration/Setup Utility program. for
information on setting the interrupt requests. If the IRQ settings are correct, call for service.
PCNTNW-NW-066 The cable might be disconnected from the adapter.
Explanation: The cable might be disconnected from the server Ethernet port.
Action: Verify that a cable is connected to the Ethernet port.
PCNTNW-NW-071 The matching virtual adapter could not be found.
Explanation: You tried to load another instance of the driver with a different I/O address. This
new adapter could not be found.
Action: Verify that you installed an IBM Netfinity 10/100 Fault Tolerant Adapter and make sure
that the adapter is seated correctly. If the adapter is seated correctly, call for service.
PCNTNW-NW-072 A resource tag is unavailable.
Explanation: The driver tried to allocate some resources that were not available.
Action: Add more memory, or free some memory resources in the server. Then, restart the
server.
PCNTNW-NW-073 Unable to allocate memory
Explanation: The driver failed to allocate the memory needed for normal operation.
Action: Add more memory, or free some memory resources in the server. Then, restart the
server.
PCNTNW-NW-074 The hardware interrupt cannot be set.
Explanation: An attempt was made to initialize a given hardware interrupt. The attempt was
not successful.
Action: Verify that the Ethernet controller is enabled. If the Ethernet controller is enabled, go
to "Starting the diagnostic programs" on page 123 to run the diagnostic programs.
If you have an Ethernet adapter installed, make sure that the adapter does not share an IRQ
with any other device.
Table 22. Novell NetWare or IntraNetWare ODI driver messages for the Ethernet controller
146
IBM® Netfinity® 7100 User's Reference
• Novell™ NetWare™ or IntraNetWare Server ODI
• NDIS Adapter for level 4.0 (Windows NT)
• SCO™ UNIX LLI