Netfinity Manager Service Descriptions - IBM Netfinity 7100 User's Reference Manual

To start any Netfinity Manager service that appears in the Service Manager window,
double-click the icon for that service. To start a Netfinity Manager service on a remote
system, use the Remote System Manager service.

Netfinity Manager service descriptions

Each Netfinity Manager service consists of a base program and a graphical user
interface (GUI). The service base programs enable Netfinity Manager to remotely
access the individual services, but do not allow for local access. The service GUIs,
when functioning along with their respective base program, enable access to the
service.
Some services are available only on systems with certain system configurations. These
services are:
•
•
•
•
•
•
•
•
•
Brief descriptions of each of the Netfinity Manager services follow. Complete
instructions on how to use each of these services can be found in the service-specific
chapters of the Netfinity Manager User's Guide.
48
IBM® Netfinity® 7100 User's Reference
Alert on LAN Configuration (available only on systems running Windows 95 or
later or Windows NT 4.0 or later)
Capacity Management (available only on systems running Windows NT 4.0 or
later)
Cluster Manager (available only on systems running Windows NT 4.0 or later)
DMI Browser (requires DMI Service Layer)
ECC Memory Setup (requires ECC memory)
Predictive Failure Analysis (requires a PFA-enabled hard disk drive)
RAID Manager (requires a RAID hard disk drive subsystem)
System Partition Access (requires a built-in System Partition)
Update Connector Manager (available only on systems running Windows NT
4.0 or later)