Event/Error Logs; Small Computer System Interface Messages - IBM Netfinity 7100 User's Reference Manual

POST message
I9990301 A hard disk drive error occurred.
Action:
POST could not find an operating system.
I9990305
Action:
If you cannot reinstall the operating system, call for service.
I9990650 AC power has been restored.
Action:
Other Numbers POST found an error.
Action:
Table 16. POST error messages

Event/error logs

The POST error log contains the three most recent error codes and messages that
the system generated during POST. The System Event/Error Log contains all error
messages issued during POST and all system status messages from the Netfinity
Advanced System Management Processor.
To view the contents of the error logs, start the Configuration/Setup Utility program;
then, select Event/Error Logs from the main menu.

Small computer system interface messages

The following table lists actions to take if you receive a SCSI error message.
Note: If your server does not have a hard disk drive, ignore any message that indi-
You will get these messages only when running the SCSISelect Utility.
Call for service.
Install an operating system. If you have already installed the operating system, check
the drive startup sequence. If the drive sequence is correct, run the diagnostic tests to
verify that the hard disk drive is functioning correctly. If there is a problem with the
hard disk drive (such as a bad sector), you might need to reinstall the operating
system.
No action is required. This message appears each time AC power is restored to the
server after an AC power loss.
Follow the instructions on the screen.
cates that the BIOS is not installed.
Description
Chapter 7. Solving problems
121