Parallel Port; Viewing Or Changing The Parallel-Port Assignments - IBM Netfinity 7100 User's Reference Manual

Refer to the following illustration for the location of input and output connectors.
Serial A
System management
Serial B
ASM Interconnect
port A
ASM Interconnect
port B

Parallel port

Your server has one parallel port. This port supports three standard Institute of
Electrical and Electronics Engineers (IEEE) 1284 modes of operation: Standard
Parallel Port (SPP), Enhanced Parallel Port (EPP), and Extended Capability Port
(ECP).
Viewing or changing the parallel-port
assignments
You can use the built-in Configuration/Setup Utility program to configure the
parallel port as bidirectional; that is, so that data can be both read from and written to
a device. In bidirectional mode, the server supports the ECP and EPP modes.
To view or change the parallel-port assignment:
1. Restart the server and watch the monitor screen.
2. When the message Press F1 for Configuration/Setup appears, press F1.
Note:
3. From the main menu, select Devices and I/O Ports; then, press Enter.
4. Select the parallel port; then, use the arrow keys to advance through the settings
available.
Note:
5. Select Save Settings; then, select Exit Setup to exit from the Configuration/Setup
Utility main menu.
Advanced Systems
Management Interconnect knockout
Keyboard
Ultra2 SCSI Mouse
The Devices and I/O Ports choice appears only on the full configuration
menu. If you set two levels of passwords, you must enter the
administrator password to access the full configuration menu.
When you configure the parallel port as bidirectional, use an IEEE 1284-
compliant cable. The maximum length of the cable must not exceed 3
meters (9.8 feet).
Parallel
Ethernet
USB1
USB2
Video
Chapter 6. Installing options
95