User Interface Display Identification - Follett chewblet 7CI100A Installation, Operation And Service Manual

Service
(continued)

User Interface Display Identification

Operation Display
––––––––––––––––––––––––––––––––––––––––––––––––––––
PM
Dispenser and Icemaker 7CI100A/7FS100A, 15CI100A/15FS100A
Condition
Normal
operation
Cleaning Mode Press and release maintenance/clean
switch to clean the user interface
without dispensing ice or water (see
Maintenance/Cleaning Mode on page
12).
Drip tray full Empty drip tray .
Six-month Follow Maintenance Mode procedure
periodic (below) and also see
maintenance Cleaning and Sanitizing Procedure on
required page 14.
Maintenance Enter Maintenance Mode by pressing
Mode maintenance/clean switch until
displays . Complete the cleaning and
sanitizing procedure shown on
14
and change the filter, if so
equipped . Exit Maintenance Mode by
pressing and holding maintenance/clean
switch until
Service - Call Follett Technical Service Group at
8000 hr
(877) 612-5086 or +1 (610) 252-7301 .
bushing check
The flashing wrench indicates that the
8000 hr bushing check is required .
Procedure
—
NSF-approved
page
no longer displays .
27