Follett chewblet 7CI100A Installation, Operation And Service Manual page 10

Installation
(continued)
3 . Remove four plastic, thread-protecting plugs from bottom of
dispenser .
4 . Attach dispenser to base stand with supplied hardware (Fig . 5) .
NOTICE!
If installing optional Drip Tray Drain Kit, refer to instructions
included with the Drip Tray Drain Kit.
5 . Connect water line . Recommended routing (Fig . 6) allows easy access
to water for cleaning and sanitizing procedure .
6 . If installing the optional internal water filter*, please see
Internal Water Filter Installation on page 11
If not, proceed to step 7 .
* If your dispenser has the internal water filter option, the water filter must be
installed for the dispenser to operate . Because internal components will need to
be accessed for both procedures, Follett recommends installing the water filter
just prior to initial sanitizing .
7 . Connect power supply .
8 . Sanitize the dispenser prior to use (see the Initial Sanitizing Kit
instructions shipped with this unit) .
10 Dispenser and Icemaker 7CI100A/7FS100A, 15CI100A/15FS100A
–––––––––––––––––––––––––––––––––––––––––––––––––
before proceeding .
Fig . 5
Fig . 6
Optional
3' (91.4 cm)
X4
Plug
Valve
1/4" MPT