Table of Contents
Advertisement
Logo
A Fluke logo shows on the display and captured images.
You can choose to turn on or turn off the logo:
1. Go to Image > Logo.
2. Push
/
to highlight on or off.
3. Push to set.
With SmartView software you can upload a custom logo to
the Imager from your PC through the USB connection.
Distance
The Imager has a laser distance finder that measures, up
to 30 meters, the distance from the Imager to a target. You
can choose to show the distance on the display in imperial
or metric units. The distance is saved to memory as part of
the image.
Warning
To prevent eye damage and personal injury:
•
Do not look into the laser. Do not point the
laser directly at persons or animals or
indirectly off reflective surfaces.
•
Do not open the Product. The laser beam is
dangerous to eyes. Have the Product
repaired only through an approved
technical site.
To do a distance measurement:
1. Point the Imager at the target.
2. Push the Laser Distance Finder button.
3. Locate the red laser dot on the target.
4. Release the Laser Distance Finder button.
The distance measurement shows on the bottom of the
display. The measurement shows as "- - - -" when not able
to take a measurement. If this is the case, steady the
Imager and retake the measurement. Or, use a tripod. The
Imager will show an error message for excessive laser
movement due to an out of range distance.
Camera Menu
The Camera menu has controls and options for secondary
camera features such as auto focus, backlight level, and
torch.
Auto Focus
The laser pointer on the Imager is both a sighting aid and
a part of the LaserSharp™ Auto Focus System. In
addition, the advanced manual focus of the Imager works
both when the auto focus system is enabled or disabled.
Warning
To prevent eye damage and personal injury, do
not look into the laser. Do not point the laser
directly at persons or animals or indirectly off
reflective surfaces.
The laser warning symbol () shows at the top of the
display when you push the Laser Distance Finder button.
Expert Series Thermal Imager
Menus
29
Advertisement
Table of Contents
