Telemetry System - FUTABA 6k Instruction Manual

TELEMETRY SYSTEM

The R3006SB receiver features bi-directional communication with a T-FHSS Air Futaba
transmitter using the S.BUS2 port. Using the S.BUS2 port an impressive array of telemetry
sensors may be utilized. It also includes both standard PWM output ports and S.BUS output
ports.
*Telemetry is available only in the T-FHSS Air mode.
*The telemetry function requires the corresponding receiver (R3006SB).
*The T6K will enter and keep the ID number of the R3006SB that it is linked to.
*When you use two or more R3006SB, set telemetry mode to INH.
T6K
●Slot Number
Servos are classified by channel, but sensors
are classified by "slot" . Since the initial slot
number of the T6K is preset at each sensor,
the sensors can be used as is by connecting
them. There are 1 ~ 31 slots.
●Telemetry sensor (sold separately)
Your aircraft's data can be checked in the
transmitter by connecting various telemetry
sensors to the S.BUS2 connector of the
receiver.
Battery voltage is
displayed at the transmitter.
Switch
S.BUS2
Port(SB2/B)
Airplane in the sky
●Receiver Voltage
●Altitude
●Engine Temperature
●Propeller R.R.M
Displayed at the transmitter
Temperature
Sensor
RPM
Sensor
HUB
Info
Altitude
Sensor
Receiver
Slot 1
Slot 2
Slot 3 ～ 5
Transmitter
47