Air Brake - FUTABA 6k Instruction Manual

6-channel digital proportional r/c system
Hide thumbs Also See for 6k:
Table of Contents

Advertisement

AIR BRK
Function
This function is used when the air brake is
necessary during landing and is turned on and off
by switch C (initial setting).
●Normally when the ailerons are used as a brake,
they are raised (UP side)
●When the operation mode is "OFST" (offset), the
air brake is controlled by switch operation. When
the operation mode is "LINR" (linear), the air brake
is operated linearly at switch ON and from the
control stick set position.
(Example)
Switch C
● Adjustment item for every wing type
Display
1AIL1FLP
AIL1(1CH)
-----
ELEV(2CH)
Elevator
FLAP(5CH)
Flap
AIL6(6CH)
-----
Method
Calling the setting screen
① Call the menu screen from the
home screen by pressing the +
key for 1 second.
Activating the function
Elevator delay rate set
● Select the setting item
with the Jog key.
108

Air brake

2AIL
2AIL1FLP
Aileron1
Aileron1
Elevator
Elevator
-----
Flap
Aileron6
Aileron6
② Select
(1 second)
AIR-BRK
Rate set
● When the "LINR" operation mode was selected, the current throttle stick position is displayed
at the operation reference point and in the bottom row parentheses.
WING TYPE
1AIL
●If the "LINR" mode was selected, the throttle stick
controls CH3 and the air brake operation, but
it can be separated from CH3 operation. CH 3
control can be switched from stick to stick or to
VR knob. However, when other than stick was
selected, the throttle trim and function reverse
functions cannot be used.
●When used in the "LINR" mode, adjust the travel
with the throttle stick at the maximum slow side
(braking amount maximum).
Flap down
WING type 1AIL1FLP or
5CH
Ailerons up
WING type 2AIL or
2AIL1FLP
ELEVON
-----
Elevator
Flap
-----
"AIR BRK"
from the menu with the
Jog key.
(AIRPLANE)
1AIL1FLP
2AIL
2AIL1FLP ELEVON
*When using a flap here, make
CH5(FLAP) NUL in AUX CH.
2AIL1FLP
6CH
③ Open the setting screen by
pressing the Jog key.
3CH Control set (LINR mode)
● When not using this Function
select INH. The display of On/
Off is shown when active and
assigned to a switch.
Switch selection
Switch direction
Mode
1CH

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents