Ordering Fuel - Viessmann VITOLIGNO 300-C Operating Instructions Manual

Ordering fuel

The pellets used must meet the requirements of
ENplus, class A1 and DIN EN 17225-2, class A1 (
ÖNORM 7135). Only use pellets with the following
properties:
Diameter: 6 mm
■
■ Length: 5 to 30 mm (max. 20 % of the pellets can be
up to 45 mm)
■ Residual moisture: max. 7 to 12 %
Delivery methods
Pellets are sold in 15 to 30 kg sacks, in bulk cartons up
to 1000 kg and in bulk.
Bulk pellets are transported by silo tanker and blown
into the storage room via a hose system.
Commissioning
The commissioning and matching up of the control unit
to local conditions and the structural characteristics of
the building must be carried out by your heating con-
tractor.
Service instructions
As the user of new combustion equipment, you may be
obliged to notify your local flue gas inspector of the
installation [check local regulations]. Your local flue gas
inspector (where applicable) will also provide you with
information on additional activities concerning your
combustion equipment (such as regular testing, clean-
ing, etc.).
Recurring emissions test
Your heating contractor must prepare the boiler for
■
this test.
■ Notify your heating contractor approx. 2 weeks prior
to the next emissions test being due.
■ Ensure that suitable fuel in line with the operating
instructions is available.
Your system is preset at the factory
Your boiler's control unit is set at the factory.
The heating circuits are set to the "Heating" operat-
■
ing program.
The domestic hot water heating is set to the "DHW"
■
operating program.
Note
: Never burn waste in this boiler.
a
Note
The pellet hopper inside the boiler has a capacity of
approx. 50 l. This corresponds to approx. 2 sacks of
15 kg each.
Prepare and carry out the emissions tests according to
1st BImSchV:
Service instructions
Prepare and carry out the emissions tests according to
1st BImSchV:
Service instructions
Introductory information
7