Adjusting The Margins For Printing - Kyocera KM-1620 Service Manual

(7-4) Adjusting the margins for printing

Make the following adjustment if the margins are not correct.
U403
U402
(P. 1-6-32)
Caution:
Check the copy image after the adjustment. If the margins are still incorrect, perform the above adjustments in
maintenance mode.
Procedure
Enter maintenance mode.
Enter "402" using the numeric keys.
Press the start key.
Select the item to be adjusted using
the copy exposure adjustment keys.
Press the interrupt key.
Press the start key to output a test
pattern using A3/11" × 17" paper.
Are the margins correct?
Yes
another mode?
Press the stop/clear key to
exit maintenance mode.
U404
(P. 1-4-36)
Start
No
Yes
Proceed to
No
End
G Copy exposure adjustment keys
Exp. 1 (lit): Printer leading edge margin
Exp. 2 (lit): Printer left/right margins
Exp. 3 (lit): Printer trailing edge margin
Press the start key.
The new setting is stored.
Change the setting.
Increasing the value using the zoom (+)
key makes the margin wider.
Decreasing the value using the zoom (–)
key makes the margin narrower.
Setting range (initial setting/change in value per step)
Printer leading edge margins: 0.0 – +10.0 (3.0/0.5 mm)
Printer left/right margin: –5.0 – +10.0 (3.0/0.5 mm)
Printer trailing edge margin: –5.0 – +10.0 (4.0/0.5 mm)
Ejection direction
(reference)
Printer leading edge margin
(3 ± 2.5 mm)
Printer
left margin
+1.5
(2.5 mm)
–2.0
Printer trailing edge margin
(3 ± 2.5 mm)
Figure 1-6-27
2C9
Printer
right margin
+1.5
(2.5 mm)
–2.0
1-6-15