2. Tighten the wire-clamp screws for preventing the wires from
loosening
1
Power 1
-
The wire gauge for the terminal block should be
in the range of 12 to 24 AWG.
Note
2.1.5 Wiring the Fault Alarm Contact
The fault alarm contacts are in the middle of the terminal block
connector as the picture shows below. After inserting the wires,
the Industrial Media Converter will detect the fault status of the
power failure, or port link failure (available for managed model)
and then form an open circuit. The following illustration shows
an application example for wiring the fault alarm contacts.
Insert the wires into the fault alarm contacts.
2
3
4
Fault
+
5
6
Power 2
-
+
15