Furuno FCV-1900 Operator's Manual page 75

[LF]
TX Pulse Edge*
TX Pulse*
Pluse Length*
RX Band*
RX Band Width*
Key Beep (Off, On), F: Yes
Key
Language (English, Others), F: Yes
Depth (m, ft, fa, HR, pb), F: Yes
Units
Speed (kn, km/h, mph), F: Yes
Temp (°C, °F), F: Yes
Fish Size (inch, cm), F: Yes
NMEA Port NMEA1, F: No
Set&Monitor NMEA2, F: No
SC, F: No
CIF, F: No
Sound Speed (200.0 to 2000.0 m/s, 1500.0 m/s), F: Yes
Calib
Temp (-20.0 to +20.0 °F, +00.0 °F), F: Yes
Bottom Level,
F: Yes
Zero Line Rejection (Off, On), F: Yes
Zero Line Area (0.4 to 3.0 m, 0.4 m), F: Yes
Zero Line Fill (Off, On), F: Yes
Draft,
F: Yes
Gain ADJ
F: Yes
Fish Size (-80 to +500, +0), F: Yes
Stabilization Stabilization (Off, On), F: Yes
Stabilization Sensor (SC-50, SC-110, SC-30), F: Yes
Stabilization Area (0 to 15 m, 15 m), F: Yes
[HF]
TD fore-aft (-100.0 to +100.0 m, +0.0 m), F: Yes
TD port-stbd (-100.0 to +100.0 m, +0.0 m), F: Yes
ANT TD height (0.0 to 100.0 m, 0.0 m), F: Yes
[LF]
TD fore-aft (-100.0 to +100.0 m, +0.0 m), F: Yes
TD port-stbd (-100.0 to +100.0 m, +0.0 m), F: Yes
ANT TD height (0.0 to 100.0 m, 0.0 m), F: Yes
Tankenmaru Tankenmaru Output (Off, HF, LF), F: Yes
Setting* 2 Pic. Sync (Off, On), F: Yes
Tests Diagnostic Test, F: No
LCD Test, F: No
Save Setting Save Setting (User1, User2), F: Yes
Read Setting (General, Surface, User1, User2), F: Yes
Save Setting External (Yes, No), F: Yes
Read Setting External, F: No
Image Replay Delete All (Yes, No), F: Yes
External Output (Yes, No), F: Yes
External USB Replay, F: No
1
(Off, On), F: Yes
(1/4, 1/2, Std, ×2, Manual), F: Yes
1
(0.01 to 5.00 msec, 0.05 msec), F: Yes
1
(Narrow, Std, Wide, Manual), F: Yes
1
(0.2 to 25.0 kHz, 0.2 kHz), F: Yes
1
* 1 : Available when the transmission
HF Bottom Level (-40 to +40, +0)
LF Bottom Level (-40 to +40, +0)
HF Draft (-30.0 to +99.9 ft, +00.0 ft)
LF Draft (-30.0 to +99.9 ft, +00.0 ft)
HF Gain ADJ (-50 to +50, +0)
LF Gain ADJ (-50 to +50, +0)
2
* : Available when the Tankenmaru
APPENDIX 1 MENU TREE
mode is [Std] mode.
system is connected.
AP-3